• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

Interior finish: how do you removal rear tractor seats on the BJ8?

Share this page

D

Dom

Freshman Member
Country flag
Offline
Dom said:
Lin/Dave/Others

I too am in the process of having Heritage redo the interior of my BJ8. I am at the point where I am trying to figure out how to remove the rear tractor seats. I don't see any obvious fasteners/screws. I did notice a bolted brace at the very back edge and bolts on each side of the rear wheel wells. Really not comfortable at this point removing these parts unless I have to. Any suggestions on how these seats are removed?
Click to expand...
 
They are pretty small diameter, but there are 4 studs attached to each seat, and the associated nuts and washers holding the seats on. You need a good light to see them from underneath. If the car has been around moisture, they may be tough to get off. Give them a good soaking in PB blaster or the like for a day or so. You don't want to break off the studs.
 
Back
Top