Hey Guest!
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
HealeyDave
Senior Member
Offline
I've been away from the resto for a while and seem to have acquired severe brain fade on some of the details of the car.
I'm trying to fit the heat shield to the intake manifold, but there are cast bosses either side of the manifold inlet ports that are interfering with the heat shield fitting up to the manifold. Actually, there are cut-outs for 2 of the bosses, but no cut-out for the 2 on the left of each port. Even with the spacers in stalled it doesn't quite fit up. I have 2 heat shields and both have the same fitting issue. I could double up on the spacers(?)
Am I missing something trivial?
Thanks for any thoughts.
Dave
61 BN7 Mk1
I'm trying to fit the heat shield to the intake manifold, but there are cast bosses either side of the manifold inlet ports that are interfering with the heat shield fitting up to the manifold. Actually, there are cut-outs for 2 of the bosses, but no cut-out for the 2 on the left of each port. Even with the spacers in stalled it doesn't quite fit up. I have 2 heat shields and both have the same fitting issue. I could double up on the spacers(?)
Am I missing something trivial?
Thanks for any thoughts.
Dave
61 BN7 Mk1
