Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
Offline
This is a terrific site! Can't believe DD makes all those Lucas components.
They even sell the cap clips, which have been unobtainable.
-
Hi Guest!
If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
There are some perks with a member upgrade!**Upgrade Now**
(PS: Subscribers don't see this gawd-aweful banner
Ignition points
- Thread starter RonR
- Start date
Share this page
This is a terrific site! Can't believe DD makes all those Lucas components.
They even sell the cap clips, which have been unobtainable.
bob hughes
Luke Skywalker
Offline
Yup, I have dealt with him on several occasions for spare parts.
Quite fair but can be a bit pricey, but there are not many places to go for distributor parts, or indeed a complete refurb and testing. he was able to sort my problem out though, first of all I needed a replacement three legged spring ( this was a used one, nobody makes them as far as I am aware ) on the underside of the fixed plate then I noticed that the hinge pin on the operating arm of the vacuum unit had almost worn through and the hole was elongated so I renewed that and the sad thing was that after I bought the new one ( it was brand new) and installed it, I looked at my old one and repaired it, so I now have a spare for the cost of drilling a slightly bigger hole and using a small section of a 2mm diameter nail for the pin ---Arrgh
Bob
Bob