hi guys,
oh boy did i f-up. while adjusting my valves today my feeler gauge set fell apart and the very small nut that held it together fell off and rolled down the where the push rods come up. it fell into the middle opening where valve 4 and 5 are. i can not see it so i assume it fell down further than i can see. its a very small nut. on a good note the small washer did not fall anywhere but on the head. i found that just sitting there looking at me and laughing. i am going to try to find a small magnetic pick up tool tomorrow and see if i can try to get anything that way.
just wondering what should be my best course of action here. i had all the valve adjusted and was just running through them again to make sure they were all ok as it was the first time i had adjusted valves.
thanks for any advice you guys have.
oh boy did i f-up. while adjusting my valves today my feeler gauge set fell apart and the very small nut that held it together fell off and rolled down the where the push rods come up. it fell into the middle opening where valve 4 and 5 are. i can not see it so i assume it fell down further than i can see. its a very small nut. on a good note the small washer did not fall anywhere but on the head. i found that just sitting there looking at me and laughing. i am going to try to find a small magnetic pick up tool tomorrow and see if i can try to get anything that way.
just wondering what should be my best course of action here. i had all the valve adjusted and was just running through them again to make sure they were all ok as it was the first time i had adjusted valves.
thanks for any advice you guys have.