• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

High-Torque Starter

Share this page

M

miraclemike

Freshman Member
Country flag
Offline
My BJ7 high torque starter was working then stopped. It makes a a noise like its hitting the flywheel but won't engage. Took it out and bench tested it, replaced solenoid and tested battery. Everything seems fine, but for some reason I hear the starter make sounds like its just hitting metal and not engaging. No spinning sounds either. Puzzled Mike
 
Did you try rotating the flywheel a bit by putting the car in gear and pushing it?
 
Same thing happened to my BJ7 so I bought another pre engaged starter and that did not solve the problem. Then I went back to the battery connections, cleaned them up and now the starter works great. I am now the proud possessor of two pre engaged starter motors along with the original one. Give it a try you never know.
:cheers:

Bob
 
BobHaskell said:
Did you try rotating the flywheel a bit by putting the car in gear and pushing it?
Click to expand...
I tried that and got the same results. I've loosened the bolts to see if there was a little different seating position, but didn't feel any change.
I've tried just to leave the bolts a little loose without success. I'm going to try shimming but not too sure which bolt or how much.
 
Is the jumper still connected to the internal solenoid?
 
You may have a short or dry joint in the electrics some where. The starter takes a big load and if there is a short then it will shudder. Turn your lights on then try the starter, if the lights dim the you have a problem in the power line

Bob
 
Check that Jumper Wire, and all connectors to the starter for corrosion. The jumper wire that included with the high torque starter I purchased was corroded and the copper wire was green. A fresh jumper was installed and the starter worked perfectly.
 
Just bridge the two 13mm nuts on the solenoid, if the starter does not spin up then its toasted,
the solenoid does two things it spins the starter and throws the the gear into the ring gear on the flywheel ,
if it just clunks with no spin then its only throwing out the gear not spinning the starter.
 
miraclemike said:
My BJ7 high torque starter was working then stopped. It makes a a noise like its hitting the flywheel but won't engage. Took it out and bench tested it, replaced solenoid and tested battery. Everything seems fine, but for some reason I hear the starter make sounds like its just hitting metal and not engaging. No spinning sounds either. Puzzled Mike
Click to expand...
I had similar problem with high torque starter on my 1956 BN2. Mine would engage but made a loud squealing sound first. I pulled out the starter and found the bearing was loose so I replaced starter to fix. I found I had just a small amount of side play but that was enough to cause noise. This may not be your problem. Just a thought. If you decide to replace I would not recommend the one from Moss Motors. Good luck, Marty
 
Back
Top