Help testing motor

[ichthos]

Mice packed my heater box and chewed the blower motor wires. Not realizing this I turned it on and a small fire started. I was able to put it out before any serious damage happened. My heater box is out of the car. I re-soldered the motor wires, and hooked it up to the battery and nothing. Before I take the motor apart, I wanted to ohm it and see what was happening before I took the motor apart. When I first turn on my ohm meter it reads 1. When touch the two test leads it reads zero. When I hooked up the positive test lead to either green wire and the negative test lead to the negative, the meter remains unchanged at 1. I am confused by this - can someone help me out?
Kevin

 

[Guest]

Circuit shows open, turn the motor while it's hooked up and see if it changes. Might have trash in it. It might be fried. I've never ohm'd a motor together. If I suspect something I've always tore 'em down and looked.

 

[Brosky]

I might have a spare motor laying around if you need one. Let me know and I'll see if I do. I don't think that I sold it with all of my other stuff, but I might have.

 

[ichthos]

Paul, I sent you a PM.

 

[Brosky]

I have a working motor, less the fan which I just tested and it works fine on both speeds and is quiet. I sent you a PM.

 

[Brosky]

It's packed up and will go to the PO tomorrow morning.