• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

HELP #2 - rear hub / brake rebuild

Share this page

That's worth a try. Sometimes they'll self align after a short drive, but I would rather have them right before I leave the hangar.
Jeff
 
I'm not to that point yet, but I had to drift my bearings in. There was no way I could press them in. For that matter, I had to drift the hub seal as it was quite a snug fit even with grease.

I would check the cylinder. I am having to send mine back as they were the wrong design.
 
Back
Top