• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

Heat insulation washers

Share this page

C

Cutlass

Jedi Warrior
Offline
There are multiple fender washers used in securing the insulating panels to the firewall and floor above the exhaust. The service parts manual lists a code for the washers that I can't decode, despite the restoration guide. The washers in my bucket of used washers are either one or one and one-quater inch diameter. Anyone know the correct dimensions for these washers? Thanks so much.
 
Those are 1.25" dia, .120" thick and have a fairly small .20" mounting hole.

Cheers,
John
 
The washers in My used bag are 1 1/4 inch diameter. they have a nuber 10 hole in the center and are about 1/8 inch thick. the replacement stainless washers I used are also 1 1/4 inch
hope this helps
Kevn R
 
Thanks, guys. I'm certain that if I can just get all the fasteners right, my BJ8 too will be worth $143,000.00.
 
Well Cutlass, John quoted the hole diameter.Kevin stated the screw size used to mount them @ 10 X 32. Skip quit trying to steal my thunder...Keoke- /ubbthreads/images/graemlins/laugh.gif
 
Back
Top