• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

Heat insulation washers

Share this page

C

Cutlass

Jedi Warrior
Offline
There are multiple fender washers used in securing the insulating panels to the firewall and floor above the exhaust. The service parts manual lists a code for the washers that I can't decode, despite the restoration guide. The washers in my bucket of used washers are either one or one and one-quater inch diameter. Anyone know the correct dimensions for these washers? Thanks so much.
 
Those are 1.25" dia, .120" thick and have a fairly small .20" mounting hole.

Cheers,
John
 
The washers in My used bag are 1 1/4 inch diameter. they have a nuber 10 hole in the center and are about 1/8 inch thick. the replacement stainless washers I used are also 1 1/4 inch
hope this helps
Kevn R
 
Thanks, guys. I'm certain that if I can just get all the fasteners right, my BJ8 too will be worth $143,000.00.
 
Well Cutlass, John quoted the hole diameter.Kevin stated the screw size used to mount them @ 10 X 32. Skip quit trying to steal my thunder...Keoke- /ubbthreads/images/graemlins/laugh.gif
 
Back
Top