• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

Gearbox front cover seal

Share this page

J

joe948

Freshman Member
Country flag
Offline
I have a smooth case front cover with scroll seal.
I'd like to machine it out and replace with rubber seal.
What's the seal dimensions and part number for the seal.
Some use metal case and some rubber coated and front and back install.
I know you can buy a cover but why make it easy.
Any advice appreciated!
Thanks
 
I put this seal in the front cover about 20 years ago. I just happen to have a spare in my transmission spares box.
I cross referenced some seal numbers and bought the seal form CARQUEST.
The box says the seal is a federal mogul 710254. It was made in Japan. I don't know if the number is CarQuest or FM. FM Number should be on their web page
OD is 1.260" ID 0.965" W is about 0.220. Dimensions may be off by a thousand or two as I am measuring the rubber
I had my friendly local machinist install. I cannot remember if we went in from the front or the rear. I somehow think it was pressed in from the nose side.
 
Thanks Joe,
That's still a good number and the dimensions look good.
Not sure if front or back will work better, will see what the machinist thinks.
Much appreciated!
Joe
 
Back
Top