• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

TR6 Gearbox fill-TR6

Share this page

W

Wike

Senior Member
Offline
After replacing the (3) small 'O' rings that surround the 3 shifting rods in the gearbox and re-assembly, went to fill the gearbox...it would only take about 16oz before spilling out of the fill hole. I thought it should take more...not sure how much, but more than it took. What have I done wrong...this time???
 
Bentley says 2 pints from dry non OD, 3 1/2 pints with A type OD and 2.66 with J type OD

you should be good to go
dont even ask what type of fluid to use or the thread will go ballistic!

Hondo
 
:iagree:
It's not all that critical. However, depending on what you are using and how cold it is, it may be worth waiting a minute and seeing if it will take more. Especially since that is two Imperial pints (2.4 US pints).
 
Hondo, we have another thread going on that already.

Let the games begin.....
 
Brosky said:
Hondo, we have another thread going on that already.

Let the games begin.....
Click to expand...

Paul is right... it's a slippery slope :smirk:
 
:lol: That was bad!
 
Back
Top