front yoke

[tomshobby]

Hi all,

I am looking for a front tranny drive shaft yoke for my '74 Midget or a fix for the one I have. The one I have is rusted to deep to clean up and use. Since I am doing a ground up on this car I want to do a good fix.

Oh, the front suspension is nearly complete. Had a few things to take care of on the TR6 so it could stay on the road, rebuilt the rear suspension, axles, and hubs. So I was away from the Midget for a couple weeks. However, I did manage to get the front wheel bearing retaining nuts turned so they fit with the taper bearings now in the car.

 

[Billm]

Tom
Anyone who has done a Datsun tranny conversion will have a spare one of these.
If there is noone who does in your area then I will be glad to send you one.
BillM

 

[tomshobby]

Thanks Bill, I will keep that in mind.

I had thought about the conversion but am not that knowledgeable about it.

 

[jlaird]

I would not be susprised if Peter C dosen't have one.

 

[tomshobby]

I would not be susprised if Peter C dosen't have one.

I will check on that. I have been down there so much lately that I almost feel he needs a break. I do have to say he has been very helpful. The trouble is that we get to talking cars and other things and a visit can become "extended".