• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

General Tech Flywheel Bolts

Share this page

DNK

DNK

Great Pumpkin
Country flag
Offline
What's the size of the flywheel bolts for the TR 2-6
I've forgotten
 
I believe they are 7/16" UNF
 
I have 6 ARP 12 point that have never been torqued.
They have been lubed and finger tightened in the holes.
I can't use them
Offer up for free
First come
 
I'm doing a clutch/flywheel/ TR6trans install on my TR3. Are the bell housing to engine bolts Grade 8 7/16 coarse?.... and are the top two bolts shorter than the rest?
 
On a TR6 I don't know if there are bolts there
 
I do believe that they continued to use the two top bolt holes for studs. I believe that this was to help you guide the tranny into position onto the back of the engine. The studs are 5/16" not 7/16" and yes they are course thread as are most all bolts threaded into the block. Yet most all of the bolts with nuts are fine thread.
Charley
 
Back
Top