jjbunn
Jedi Knight
Offline
I'd like to get an idea of how much a body shop might charge to replace a floor pan in a TR6. The car I'm looking at has a an area of maybe a couple of inches at most of rust-through at the outside edge of the front-most position of the pan.
Other than replacing the whole pan, is there a good way of patching a hole like that, or is it a bad idea?
I'm assuming (perhaps wildly optimistically) that the rust is confined to the pan /bcforum/images/%%GRAEMLIN_URL%%/smile.gif
Other than replacing the whole pan, is there a good way of patching a hole like that, or is it a bad idea?
I'm assuming (perhaps wildly optimistically) that the rust is confined to the pan /bcforum/images/%%GRAEMLIN_URL%%/smile.gif