T
Tinster
Guest
Guest
Offline
I'm about to get into some rust stabilization
prior to installing Crypty's new wool carpet
interior. This topic is appearing now in several
threads. After Bill nightmare with the red lead,
I started doing some research on rust and so did
some other folks here.
The product "Rust Bullet" was mentioned many times
in my own research and also here in the forum. This
appears to be a very viable rust stabilzation product.
https://www.rustbullet.com/index.htm
They do not ship to Puerto Rico "because PR is not part
of the United States". So I called them and spoke to a
knowledgeable tech guy named Frank Frank@rustbullet.com
They have a dealer about ten miles from my house. Frank
said to tell everyone on the formus to e-mail him with any
questions.
Frank said the standard formula mix is just fine for general
use where it will not be seen. He said the automotive
formula is a thinner mix compounded so it can be spray gun
applied to outer body panels.
I'll try to pick some up next week, try it out, and report back. I have some mild rust on the rails the tranny cover sits upon. Need to correct it before the carper install.
Lets hope for positive results and no nightmares like poor
Doc Bill.
dale.
prior to installing Crypty's new wool carpet
interior. This topic is appearing now in several
threads. After Bill nightmare with the red lead,
I started doing some research on rust and so did
some other folks here.
The product "Rust Bullet" was mentioned many times
in my own research and also here in the forum. This
appears to be a very viable rust stabilzation product.
https://www.rustbullet.com/index.htm
They do not ship to Puerto Rico "because PR is not part
of the United States". So I called them and spoke to a
knowledgeable tech guy named Frank Frank@rustbullet.com
They have a dealer about ten miles from my house. Frank
said to tell everyone on the formus to e-mail him with any
questions.
Frank said the standard formula mix is just fine for general
use where it will not be seen. He said the automotive
formula is a thinner mix compounded so it can be spray gun
applied to outer body panels.
I'll try to pick some up next week, try it out, and report back. I have some mild rust on the rails the tranny cover sits upon. Need to correct it before the carper install.
Lets hope for positive results and no nightmares like poor
Doc Bill.
dale.