• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

Engine Rebuild -What to keep and what not to keep?

Share this page

Good stuff Hap. I was going to contact you for tips and advice as you seem to be one of the resident pro's on the subject of engine rebuilding.

This is my first and definitely not my last. I hope to do more of these for myself and some local club members if I can. I've been wanting to do this since I was about 15 and now 25 years later I'm finally getting my chance.

I used the original thrust washers, oil pump studs and the cam thrust plate.

So far all is going well.
 
How about head studs? Should they be replaced.

Oil pump should be chucked too I'd assume. Does the gear go along with it?
 
You can mic an oil pump to see if itsw within tolerance & buy the parts to make it right.....if its a daily driver, I'd pull the head studs & examine them closely &, if the engine's not been rebuilt before, think about reusing them.
 
Back
Top