-
Hi Guest!
You can help ensure that British Car Forum (BCF) continues to provide a great place to engage in the British car hobby! If you find BCF a beneficial community, please consider supporting our efforts with a subscription.
There are some perks with a member upgrade!**Upgrade Now**
(PS: Subscribers don't see this gawd-aweful banner
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
Engine Bay 99% Complete
- Thread starter John Moore
- Start date
Share this page
OP
John Moore
Luke Skywalker
Offline
I used allen plugs. It's been so long, I don't remember the size, but the are available at most hardware stores. But it's very clean.
tony barnhill
Great Pumpkin - R.I.P
Offline
John - can you loose the washer & still maintain vacuum?
OP
John Moore
Luke Skywalker
Offline
Here is the solution. I put 1 3/4" 5/16" studs in the two manifold holes. I put a nut at the bottom and one on top of the clamps. It brouht the pipe up to the perfect height. Yay!
And for grins I used the same studs to add chrome acorn nuts on my T-stat housing! lol!
And for grins I used the same studs to add chrome acorn nuts on my T-stat housing! lol!
tony barnhill
Great Pumpkin - R.I.P
Offline
Now you need chrome acorn nuts to hold the copper pipe in place!