Hi Guest!
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
Offline
M'lady's MGB suddenly quit running (luckily in the driveway) while at idle and refused to relight. I was fussing with Weber jetting. A sudden "no spark" condition. After some poking about I got "scientific" and broke out a 12V test light. Power at the coil input, naught from the breaker side. Pulled the dizzy out and swapped the condensor, spun up the engine. No Joy. Pulled the coil, and ohmed it. Tested FINE. I put the meter probes on the RIVETS for the test. Some should see where this is going, it is not uncommon.
The bloody rivet on the breaker side of the coil apparently was just loose enuff to allow some corrosion and wasn't making good contact. I've seen this on many other occasions with cars that have been thru the shop, have had it happen with the Tin Lotus back-when, too. I spent too much time fussing with pulling the distributor, coil, swapping parts, testing the coil with a meter. A simple "wiggle test" in the first place would have taken a few seconds... I'd forgotten the lesson learned many years ago. :madder:
The bloody rivet on the breaker side of the coil apparently was just loose enuff to allow some corrosion and wasn't making good contact. I've seen this on many other occasions with cars that have been thru the shop, have had it happen with the Tin Lotus back-when, too. I spent too much time fussing with pulling the distributor, coil, swapping parts, testing the coil with a meter. A simple "wiggle test" in the first place would have taken a few seconds... I'd forgotten the lesson learned many years ago. :madder:
