-
Hey Guest!
British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!**Upgrade Now**
(PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
TR2/3/3A Differential cover torque
- Thread starter weldersa
- Start date
Share this page
Offline
Sound about right. Same as the sump isn’t it ?
doesn’t need to be too tight.
doesn’t need to be too tight.
I usually cut my own gasket for that out of a heaver gasket paper because the aftermarket gasket for the differential always seem too thin and then still put some sealer on one side. I knew a shop that would use only RTV and then tighten the cover just a little and then then next day snug it to torque specs
steve
steve