TR2/3/3A Demisterr vent routing

[Dr_Mike]

I am looking for the route for the duct to the left hand demister vent, and not having much luck. over/behind/ under the original heater core? Photo would help a lot.
Thanks

 

[TR4nut]

Over!

https://www.britishcarforum.com/bcf/showthread.php?90819-TR3-heater-install-picture-needed

 

[2liter4cyl]

Over for sure, but don't block the cowel vent. Le

 

[Dr_Mike]

Thank you both. I will put it together this afternoon , and hopefully get a photo to post to see if it meets with approval. Methinks it will look like a cat's cradle!
( Does it go down through the steering column bracket first?)
Michael

 

[Dr_Mike]

her are two not so good photos of the duct as it goes over the top 9 well really, jut behind the top), and avoids the oil pressure pipe. Does this look right? It won't squeeze through further forward: too much competition for space.
Or should I be using a different duct material?
michael

 

[Dr_Mike]

Those are beautiful photographs, and illustrate more than i had asked for. Thank you. (Missed the link first time round.)

i notice you have done some things differently and will have to review some of my anatomical choices. If I have more queries can I contact you offline?
michael

 

[TR4nut]

Actually those aren't my cars but posting from a few active individuals on this board who have been down this path as well- I'm sure they wouldn't mind an offline question but I suggest you just keep posting to this thread and I bet they will chime in. I'd offer more direct help myself by my 3A is stored in New York at the current time so I can't grab any quick photos