Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
I'm installing the dash lighting and wiring on my BN7, (april 1959 build date) I purchased the car as a basket case so no referance. The dash lighting on the tach and speedometer is no problem, however on the temp and fuel gage all that is provided is a metal type holder attached to the gage hold-down bracket that would place the lighting bulb over the top, but outside of the gage, no cover or real method of directing the light into or over the gage face. A small slot runs around the gage but has a plastic dark colored piece that would prevent much light from shining into the gage. The light bulbs, as are, would do an excellent of lighting the back side of the dash but not much else. Am I missing some parts, or does the dark plastic ring need a gap to allow light into the gage? O r is this just the way it's suppose to be?? /ubbthreads/images/graemlins/confused.gif
-
Hi Guest!
If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
There are some perks with a member upgrade!**Upgrade Now**
(PS: Subscribers don't see this gawd-aweful banner
Dash lighting
- Thread starter krag50
- Start date
Share this page
BlueRidge1
Jedi Warrior
Offline
The Light just shines through the slots. make sure the bracket doesn't short out any of the other wiring on the switches . Not sure if it matters if the bracket puts the bulb on top or bottem you may have to experiment both ways.
If I remember correctly if I put the bulb on top of the gas gauge the bracket hit the headlight switch. I have the one on top that serves the oil pressure water temp. and it is very close to bumping the start button.I think the ring piece is to keep it from blinding you. Some vehicles used red dash lighting because it doesn't disturb your night vision. Bob
If I remember correctly if I put the bulb on top of the gas gauge the bracket hit the headlight switch. I have the one on top that serves the oil pressure water temp. and it is very close to bumping the start button.I think the ring piece is to keep it from blinding you. Some vehicles used red dash lighting because it doesn't disturb your night vision. Bob
