• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)

General Tech CRANK SPROCKET SHIMS

Share this page

Darwin

Darwin

Jedi Knight
Bronze
Offline
Is it normal to need .037 in shims behind the crank sprocket to get it to line up with the cam sprocket or am I doing something wrong?
 
It's good that you checked the alignment. Many builders would have missed it! But, +1 for doing what it takes to get perfect alignment. Be sure the cam is seated fully against the block and not stopped against a lifter or the rear cam galley plug.
 
If position and end play are right, use whatever thickness it takes. The Moss catalog mentions a procedure found in the service manual, which might add confidence.
Bob
 
yes. I'll give it a try tonight. Thanks all.
 
Back
Top