• Hi Guest! Being a Paying Supporter is NOT a requirement to participate at BCF. However, subscribing will help ensure we can continue to serve the LBC community for years to come. If you enjoy BCF and find our forum a useful resource...Please consider supporting us by **Upgrading**
    (PS: Subscribers don't see this banner)
Tips
Tips

TR2/3/3A Crank Oil Slinger Orientation

M_Pied_Lourd

Darth Vader
Country flag
Offline
Hi Guys,

Just reassembling the timing chain cover on the engine and have a question regarding the keyed oil slinger on the crank. The slinger has a slight dish on it. I assume the flat part should sit against the crank gear? Does this sound right?

Cheers
Tush
 

TR3driver

Great Pumpkin - R.I.P
Offline
Yup. "fit the oil deflector to the crankshaft so that the raised edge faces the timing cover." - paragraph xxi "Reassembling Engine" page B34 TR2/3 workshop manual.
 
OP
M_Pied_Lourd

M_Pied_Lourd

Darth Vader
Country flag
Offline
Thanks Randall, I appreciate it. Back to the garage.

Cheers
Tush
 
Similar threads
Thread starter Title Forum Replies Date
GTP1960 TR2/3/3A Timing cover/crank hub oil seal Question Triumph 4
T TR4/4A Oil drain hole from rear crank seal/rear main cap Triumph 3
S Rear crank seal oil leak BN2 Austin Healey 20
rjc157 moss rear crank oil seal Austin Healey 4
dklawson Spitfire Crank Endfloat and Oil Pumps - Spitfire 1500 Triumph 9
Got_All_4 YIPS Took out 4&1/2 gal oil & gas from crank case Triumph 18
W TR6 TR6 Crank oil seal sleeve Triumph 4
A Clutch Replacement + Rear Crank Oil Seal Replace? Austin Healey 8
nichola TR6 Door handle and window crank installation Triumph 0
D TR2/3/3A TR3 throttle linkage bell crank. Triumph 13
R Wanted 3 main crank MG Classifieds 1
Twit early TR4 Crank Handle wanted Triumph Classifieds 0
P TR6 Tight window crank Triumph 9
71TR6 Triumph TR4 Coventry Radiator with crank hole- recently refurbished Triumph Classifieds 0
D TR2/3/3A TR3A Crank Dog Triumph 2
K TR2/3/3A The timing mark on the crank pulley.... Triumph 5
K For Sale Starter Hand Crank Triumph Classifieds 0
J 1275 EN40 Crank Spridgets 5
J TR2/3/3A Flywheel-Crank Dowel Alignment Triumph 6
R TR2/3/3A Extension Crank Bolt Attachment Triumph 12
M Wanted TR3 Hand Crank Guide Triumph Classifieds 3
Alfred E. Neuman TR4/4A TR4 fan extension and crank bolt length Triumph 9
D TR2/3/3A Crank handle support Triumph 11
Got_All_4 TR2/3/3A Hand crank misalignment Triumph 9
K For Sale TR3 crank handle Triumph Classifieds 0
M Wanted TR-3 Crank Handle Triumph Classifieds 3
R TR2/3/3A Temperature Gauge for 1954 TR-2 & Hand Crank Triumph 17
Got_All_4 TR2/3/3A TR3 engine hand crank Triumph 14
ckeithjordan Wanted WTB: TR3 Crank Handle Guide Stays Triumph Classifieds 1
Drone Dog BT7 tri-carb installing my crank Austin Healey 4
R General Tech Crank bearing cap broke...Torque?? Triumph 37
Rut Crank/flywheel dowels Spridgets 3
R TR2/3/3A One more crank pulley question Triumph 7
R TR2/3/3A Crank pulley question Triumph 4
Boggsy64 MGB Crank doesnt turn freely - new main brgs MG 21
jfarris TR2/3/3A TR3 tining without marks on crank pully Triumph 6
T Replacing the crank pulley/damper Austin Healey 4
T TR4/4A How to determine if the crank is good before pulling the engine out Triumph 8
R Crank damper alignment Austin Healey 6
R timing gear crank shims Austin Healey 11
R Dennis Welch Rear Crank seal conversion - Gap in back plate Austin Healey 19
R Engine crank shaft nuts Austin Healey 1
B Remove Crank Nut Austin Healey 55
S TR4/4A Water pump and crank nose questions Triumph 7
GTP1960 TR2/3/3A Removing the fan extension from the Crank hub Triumph 13
T TR2/3/3A How many guide holes in TR3 flywheel for crank pin? Triumph 2
M Crank Pulley Removal Austin Healey 12
J General TR Narrow Belt crank pulley Triumph 0
K TR2/3/3A Su carb rod linkage bell crank stud? Triumph 6
CJD TR2/3/3A Crank balancing Triumph 11

Similar threads

Top