• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

Clutch release arm / fork gaiter ; Toyota 5 speed conversion

Share this page

B

BBH

Senior Member
Country flag
Offline
All,

Re the Toyota gearbox conversion and specifically in respect of the bellhousing, there is a rectangular hole where the clutch release fork comes through to link with the slave cylinder. With the kit I purchased I didn’t get any form of gaiter /
seal, but I have seen mention of them.

Does any-one have a part reference (Toyota or otherwise) for the gaiter / seal.
 
Just curious did you get your kit from Pete anyway the number your looking for is Toyota bellhousing rubber #31126-20060 good luck
 
Many thanks for the part number reference - just what I was looking for.

Re the kit, I did try to contact Peter a few times (e- mail and phone) but no-Lucy so I bought a kit from a UK supplier
 
Back
Top