Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
Now that the driving season is winding down, I'm starting to clean my cars for their winter naps. Behind my grill, in the empty space, it got pretty dirty. How can I get behind there and clean it? My thought was to remove the grill, but I'm not sure how to do that. Any ideas? Pictures even?? Thanks!
-
Hi Guest!
If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
There are some perks with a member upgrade!**Upgrade Now**
(PS: Subscribers don't see this gawd-aweful banner
Clean behind the Grill on a 100
- Thread starter Pizzi348
- Start date
Share this page
Online
The grille removes easily after you unfasten from the inside the--five I think--nuts that secure the corners and top edge. You can do this through the wheel wells.
If your car is an overheater, esp. in traffic, now would be a good time to consider an electric fan that fastens to the braces in front of the rad. You will have to remove the vertical divider which serves no purpose other than preventing one's seeing "airspace" through the wheel openings when viewing the car from the side.
If your car is an overheater, esp. in traffic, now would be a good time to consider an electric fan that fastens to the braces in front of the rad. You will have to remove the vertical divider which serves no purpose other than preventing one's seeing "airspace" through the wheel openings when viewing the car from the side.
Offline
Michael is exactly right, I will only add that if you can get a squirt of WD40 or PBblaster on the nut and stud before removal so much the better, as it is possible to break the studs off (you can probably figure out how I know.
You can get in there by turning the front wheels to full lock so you can get your arm in there, a racheting wrench works well for this job.
Greg
You can get in there by turning the front wheels to full lock so you can get your arm in there, a racheting wrench works well for this job.
Greg