• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)

Carpet Fitting

Share this page

mountainman

mountainman

Jedi Trainee
Offline
I bought a new carpet set for my Tr3 last December off Ebay. It has been stored in the box since then and has some bad winkles where it was folded. Does anyone here know I good way to get them out so it will lay flat.
Thanks
Greg
 
If you have a sunny day and the carpet is black you may find that a few hours sunbathing (the carpet not you) will help. Much of this may resolve itself once the carpet is in place.
 
Try hitting it with high steam from a steam iron. Depending on the material, you might want to avoid contact with the hot iron as same materials may melt. So use an old sheet or similar between the two.
 
If you can hang it a fabric steamer would help.
 
If you don't have a steamer or high powered steam iron, take them to the dry cleaners and get them to steam the wrinkles out.

Dan B
So. Chas. WV
66 TR4AIRS EFI
80 TR7 DHC
 
I had similar problems with a carpet set that has been in the box for many years. Just laying it flat on the floor for a week or so made a world of difference.
 
I have one of them new fangled dryers that has a drying rack inside of it....not sure if you have one. I find a light misting with water sprayed from a spray bottle and the dryer on hi heat works well.

Cheers,
M. Pied Lourd
 
Between the dryer hints and Bobby sewing, you 6 pack guys are so "Susie Homemakerish"
:laugh: :laugh:
 
Wait till you see me cook Don. I will make someone a good Wife :wink:

Cheers,
M. Pied Lourd
 
Back
Top