• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

Carpenter knowledge needed

Share this page

Well I built a little jig to install the threaded insert.
Wish the press I borrowed from my neighbor had a clamping device on it so that I could hold it still.
When I tried to bore the lag out it got a little crooked.
So when I drilled my pilot hole for it...well it didn't quite get centered
View attachment 29925
 
Next question
The inserts are brass.
The bolt I am using is brass.
Cut the head off and cleaned the threads.
Should I glue the stud into one of the pieces??
If so...the post or the Finial??
 
I wouldn't bother with glue. I would just drill the hole in the post shallow so the stud could screw in only so far before it stopped. Then put a bit of anti-corrosion (Corrosion-X or similar) substance in the insert before screwing on the finial. You're just securing a non-load bearing finial to a post. The attachment doesn't demand much strength.
 
Does the silver anti seize work on brass?
 
Silver anti-sieze works if the brass is being connected to a dissimilar metal and won't be subjected to heat.

In this case, just put a bit of silicon grease on it. You're only trying to seal it a bit from the atrmosphere.
 
This atmo is like where you are now.
Hard to keep that stuff out of things!
 
I hear you!! That's why in the absence of something like Corrosion-X, a silicone grease might be a good bet. There is also a product we use in airframe maintenance called Fluid Film ( https://www.fluid-film.com/products/.)

It was developed for the Navy to keep marine equipment from corroding and it's still popular today. It's a solvent-free corrosion preventive composed primarily of lanolin (wool wax). It can be bought online and retailers I don't know about but I also know that John Deere dealers sell it as well...12 oz aerosol can about $7. I keep a couple cans handy here.
 
Last edited:
Back
Top