• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

TR6 carbs

Share this page

sundown

sundown

Jedi Hopeful
Offline
Hi what's the trick to attaching the carbs to the manifold I can't get a good hold on the nuts to start on the stud. There is no clearance. Should I put the carbs on manifold then put the whole assembly on.
 
. Are you even having trouble getting the nuts with lock washers on top started ?
If so, since there isn't a whole lot of room maybe move the carb back away from the manifold a tad then see if you can get the nut started using your finger tips.
If that doesn't help, then I guess the studs aren't in right.
 
Thanks going to try that tomorrow. It's just a pain, I am using needle nose pliers to try and get them started. What an ordeal. Thanks
 
Back
Top