-
Hey Guest!
British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!**Upgrade Now**
(PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
Car dies suddenly
- Thread starter Michael Oritt
- Start date
Share this page
Bob_Spidell
Yoda
Offline
This makes sense, if my understanding of how a ballasted system works is correct: in such a system, the full 12V is sent to the coil for starting, but for normal running the ballast resistor cuts the voltage by about half. If the resistor was intermittent, you'd get random engine stoppages. I think you found the problem.
OP
Offline
Bob--
Your understanding is correct. However I decided not to run a direct line (12VDC) from the starter solenoid to the coil for full starting current and have never had a problem firing off on the reduced voltage.
Looking at the resistor on the bench it is amazing that it conducted any power to the coil and obviously it was being held together by the fastener's pressure.
Your understanding is correct. However I decided not to run a direct line (12VDC) from the starter solenoid to the coil for full starting current and have never had a problem firing off on the reduced voltage.
Looking at the resistor on the bench it is amazing that it conducted any power to the coil and obviously it was being held together by the fastener's pressure.