• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)

Camshaft Endfloat

Share this page

Bruce_B

Bruce_B

Jedi Warrior
Offline
Just put in the camshaft, oil pump and camshaft retaining plate. Endfloat measures about .021, specs say it should be .003 - .007, if not put a new endplate on.

Any ideas how I could be so off? Used a dial indicator...
 
You did have the front gear on the cam when you made this measurement didn't you? The endfloat is controlled by the fit of the triangular front retaining plate to the cam front journal and the back side of the timing gear. If 0.021 was measured with the gear installed and all the bolts tightened up, check the thickness of the front retaining plate. They wear down where the timing gear rubs on them.
 
I bet not(gear in place). If the gear was on and 0.021" was the float, the wear on that plate would be highly visible, methinks. It's buttin' into the pump at full rearward movement. Gear on, it'll be a LOT less.
 
Well...just reread assembly directions and saw that one set doesn't mention the gear, another set does. Thanks everyone for their input.

Sure sounds like that should be the problem. Be checking it later today.

Da*n...this board is good!
 
Doug's da man. /bcforum/images/%%GRAEMLIN_URL%%/wink.gif
 
Schucks Dr. (looking down at floor and shuffling feet), thanks.
 
Back
Top