but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
RestoreThemAll
Jedi Warrior
Offline
I'm working from a Bentley manual and don't find a torque spec for the cam gear nut on my BJ7. I'm guessing not much. 40#?
Dale
Dale
-
Hey Guest!
British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!**Upgrade Now**
(PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Cam gear nut correct torque
- Thread starter RestoreThemAll
- Start date
Share this page
Randy Forbes
Yoda
Offline
There is a lock-tab for that fastener, but if you say you can't find the value in the Bentley, then 40 Lbs seems like a reasonable number...
If you really want to be thorough, you can measure the thread diameter & thread pitch, and look up the value for those parameters. Off the top of my head, I can't tell you what value I put on there__I've slept since I did the last one!
If you really want to be thorough, you can measure the thread diameter & thread pitch, and look up the value for those parameters. Off the top of my head, I can't tell you what value I put on there__I've slept since I did the last one!
OP
RestoreThemAll
Jedi Warrior
Offline
I often overthink it. The nut didn't tighten anymore past 20#. I took it to 40#. The camshaft has very little end play, maybe .002.
Thanks once again Randy.
Dale
Thanks once again Randy.
Dale