-
Hi Guest!
If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
There are some perks with a member upgrade!**Upgrade Now**
(PS: Subscribers don't see this gawd-aweful banner
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
Bumper Packing Piece
- Thread starter dezand
- Start date
Share this page
British_Recovery
Jedi Warrior
Offline
It's a metal square with a hole in the middle and a nub in each corner to spread the contact surface from the flat bumper bracket to the bumper. Without them, the high point of the inner bumper recess can roll up or down. Bob
D
Duane_Rhynard
Guest
Guest
Offline
Nick,
They are metal, 0.125" thick, 1.25" square. Picture of both sides below:
Duane
'58 BN6
Yorba Linda, CA
Click to enlarge
They are metal, 0.125" thick, 1.25" square. Picture of both sides below:
Duane
'58 BN6
Yorba Linda, CA
Click to enlarge