Hey Guest!
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
Offline
Hi folks,
I have installed hubs and bearings on Sprites and Big Healeys a half a dozen times over the years. Don't ever recall having a problem. Today I experienced a problem with the Bugeye that can be seen in the very short video below. While this is a Bugeye, the set up is basically the same as with Big Healeys. The axle and hub are from the Bugeye. The brake backplate/brake assembly is newly acquired from a 71/72 midget. The bearings were already in the hub. I didn't change them or the seal since all seemed good. Have I just missed something silly? Any ideas? Thank you!
Lin
I have installed hubs and bearings on Sprites and Big Healeys a half a dozen times over the years. Don't ever recall having a problem. Today I experienced a problem with the Bugeye that can be seen in the very short video below. While this is a Bugeye, the set up is basically the same as with Big Healeys. The axle and hub are from the Bugeye. The brake backplate/brake assembly is newly acquired from a 71/72 midget. The bearings were already in the hub. I didn't change them or the seal since all seemed good. Have I just missed something silly? Any ideas? Thank you!
Lin