• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)

Bondo valance to fenders?

Share this page

zimmy

zimmy

Jedi Knight
Offline
i was considering bondoing the fenders to the valance on the front of the car under the grille.....other than taking it apart, which i plan to never do again, does anybody have a good reason to not do it......would look alot nicer ...zimmy
 
Cracking. How about lead or lead-free body solder? Not hard to do.

Paul
 
Very hard to lead those since they are "upside down".

Don't do it Zimmy. At some point you may be forced to take them apart. Anyway, if I was looking to buy a midget and saw that joint filled, I would be very hesitant.
 
I put seem sealer in the crack, I kind of like the look of the seam. I also filled the bumper holes as I am not putting the front or rear on my 65.

Mark
 
Those seems let the car breath, let dust and air in and out. I think they help keep it from rusting up there but I could be wrong. My PO filled in the spaces over the arcs and this caused major rust. I would leave the gaps.
 
Agree with all the above. You'd have to be really good to do lead and, with the joint under it, the bondo will crack in short order.
 
If you were to body fill it I would reco. seam weld it first and try to grind it smooth. But trust me when that motors gotta come out it is so nice to tear apart that mid section. (I converted my 1500 to the early bolted style just for that reason)
 
Back
Top