Trevor Jessie
Yoda
Offline
I had some free time last night and today, so I thought I'd tackle one of the rear quarters on the bugeye project. I wish I had taken a few more pictures so that you could see how bad it was.
After I pulled out all the Bondo and mesh I forgot about documenting the process. Instead I just cussed for hours on end. After cutting, bending and pounding out some patch panels. I contorted myself into all the strange positions required to get the panels welded in place. It was warm enough today to roll the car outside for the grinding mess.
Anyway, it is basically done. When I'm ready to do the body work this section should only need a little more grinding and a THIN layer of fiberglass (unlike the gallon the DPO used).
After I pulled out all the Bondo and mesh I forgot about documenting the process. Instead I just cussed for hours on end. After cutting, bending and pounding out some patch panels. I contorted myself into all the strange positions required to get the panels welded in place. It was warm enough today to roll the car outside for the grinding mess.
Anyway, it is basically done. When I'm ready to do the body work this section should only need a little more grinding and a THIN layer of fiberglass (unlike the gallon the DPO used).