• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

TR2/3/3A Blade-less bumper in TR3A

Share this page

J

Jesus

Senior Member
Country flag
Offline
Hi all,

I am considering removing the front bumper blade and fitting only overriders (some rear ones) as shown in the attached photo, picked up from the internet.

Can somebody propose some kind of fixture that can use the existing body holes and fixing points in the TR3A?

Thanks for your comments.

Jesus
 

Attachments

  • TR3A.JPG
    TR3A.JPG
    40.5 KB · Views: 158
It looks like they used the top brace as usual. Then they fashioned a little stub bracket that goes sideways (inboard) from the stock lower mount to the bottom of the overider. So all you would have to do is fashion the small lower bracket.
 
Back
Top