• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

bj8 trans problem

Share this page

rjc157

rjc157

Jedi Warrior
Country flag
Offline
i have a 66 bj8 and i just changed the clutch pressure plate and throw out bearing and put in a new slave cylinder bled it and the rod moves the whole distance my prob is that i can't get it to go in gear any thoughts
 
Just a guess : May have gotten the wrong throwout bearing, or there is excessive wear in the pin / push rod end hole causing slop in the push rod--Keoke
 
Back
Top