BJ7/8 Door Seals

[HealeyRick]

There are supposed to be a tiny screw and a chrome clip that hold the end of door seal when it makes the turn onto the rear interior trim panel. Does someone have a picture of where the screw goes as well as the chrome clip?

Thanks,,

 

[John Kuzman]

Rick -

You have a PM.

 

[PeterB]

Rick -

You have a PM.

John,

Is it possible to get a copy of the same pic? I am almost at that stage of installing my interior and I have the same question.

Thanks,
Pete

 

[John Kuzman]

I think I found a way to reduce the size of the attachment to meet the BCF size requirements. I do not remember who sent me these instructions, but they are very helpful. I think I also have pictures of the clip that attaches the Bristleflex to the rear panel edge.

 

[John Kuzman]

Here are a couple of pictures taken at a recent show.

 

[bob hughes]

Yup John

That is what I have done with mine too, I might have taken mine a bit further along the inner quarter panels.



Bob

 

[RAC68]

Hi Rick,

I also added an additional trim-collored screw about 5" below the one described in John's MacGregor document to assure tight active-side placement retention of the weather strip during consecutive door closes.

Ray(64BJ8P1)

 

[HealeyRick]

Thanks for all the help, should be able to take care of the floppy ends of my seals