Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
robert_ellison
Jedi Trainee
Offline
What is the best method for removing the rear brake cylinder? I have hose disconnected, hand brake lever removed, but cannot figure out the rest.
Thanks for the assist!
Thanks for the assist!
-
Hi Guest!
If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
There are some perks with a member upgrade!**Upgrade Now**
(PS: Subscribers don't see this gawd-aweful banner
BJ-7 rear wheel cylinder removal
- Thread starter robert_ellison
- Start date
Share this page
Randy Forbes
Yoda
Offline
The two (2) retaining plates slide together from opposite sides, into a groove on the back of the wheel cylinder. You have to "lift" the plate on the top to clear the tangs of the one underneath; at the same time, pushing the top plate past the bottom plate.
If need be, I can set up a mock installation with some loose parts I have on hand, and get you a couple pictures (busy day today though...).
If need be, I can set up a mock installation with some loose parts I have on hand, and get you a couple pictures (busy day today though...).
OP
robert_ellison
Jedi Trainee
Offline
Thanks for the replies!
Yes, I would appreciate an installation/disassembly break down as I tried prying up the tips, banging on it with a hammer/screwdriver etc with no success.
Yes, I would appreciate an installation/disassembly break down as I tried prying up the tips, banging on it with a hammer/screwdriver etc with no success.
OP
robert_ellison
Jedi Trainee
Offline
In answer to my own question. I finally removed the cylinder by tapping at the right hand side top plate with a punch and hammer. I did not find it necessary to lift the tabs. I don't remember whether it was because they were installed incorrectly or what but I'll check and update.