• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

Bearing Help Please

Share this page

HealeyRick

HealeyRick

Yoda
Silver
Country flag
Offline
I'm installing my hubs on a new Denis Welch Racing stub axle. All new Timken bearings. When I fit everything together with no shims and tighten the castle nut to 40 ft/lbs, I am unable to move the hub. If I tighten to about 20 ft/lbs the hub moves freely with no end float. I don't see any issues with the hubs and the bearing races are fully seated. Is it acceptable to install without shims and only the 20 ft/lbs as long as I can get the cotter pin installed or am I doing something really wrong here? I'm a little gun shy about destroying the new stub axle given the price of a new one.

Thanks in advance,
 
Rick
You're not doing anything wrong, you just need to add shims until you get excessive end float, noting the total shim thickness. Then measure the end float and remove shims until you get the nut tight and no end float. Good detailed info on page 248 of the Bentley manual.
Dave
 
Back
Top