• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

Basic trunnion question

Share this page

T

tdskip

Yoda
Country flag
Offline
OK - and I'm ready to duck because my question will point out that I haven't done this on any of the cars yet - but on an installed trunnion do you oil it from the rear/top bolt?

trunnion.jpg



(in my defense the cars have all been essentially in the garage being made road worthy so I haven't been driving them without address this this)
 
The trunnion is oiled through the vertical link via a "grease" fitting. For initial assembly, I poured oil into the trunnion. When fully assembled, the dog leg will hold the stop for the vertical link.
 
Thanks guys - neither of the trunnions on the car currently has a zerk on the bottom so I guess I'll "just" using the zerk on the vertical link will have to do until I eventually pull these as part of refurbishing the links and hub etc...

Thanks!
 
Yep, on the 2-4 it is on the bottom, on the 250 and 6 it is on the vertical link.
 
:iagree: with the caveat that the 4A also had the later style trunnion and earlier cars may have been retrofitted.

Also worth noting that the factory recommended grease for the zerk on the bottom, oil for the zerk on the VL.
 
Back
Top