• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)

Axle nuts

Share this page

M

mylesw

Jedi Hopeful
Offline
Hello

Very quick question - what size are the front and rear axle nuts on a BT7? I need to get a socket to fit and need to know which size to get.

Thanks

Myles
 
8 sided, 56mm socket. It's not available in a regular US store. 6 and 12 sided ones don't work. AHSpares sells one, or you might have luck borrowing one from a Healey friend like I did. Also Left side one is reverse threaded!
rich
 
A 1-1/8" deep socket fits the front stubaxle. I didn't like the stamped-steel "sockets" available for the rear hub, so I made my own.

IMG_6560a.jpg


IMG_6562a.jpg
 
There's somebody selling them on Ebay
https://cgi.ebay.com/ebaymotors/MGA-Austi...=item2309009b17

Also recently an original factory Churchill tool sold and I noticed it has a bar through the middle which locates in the axle housing to take the side load from tightening it. that means the nut only gets the rotational force and there is no chance of it slipping off.
 
Moss or British Car Specialists sells the stamped socket . The MGA takes a smaller one than the Healey both are octagonal. I've used mine with an impact and they've held up ok. Randy's would last longer obviously. Only if you were doing this job daily would the Churchill tool be necessary as its way overbuilt. The nuts are a little pricey , try not to ruin them when you remove them. Kevin
 
Oops yes, thanks for pointing that out John. There was a correct socket listed a few months back, just not that particular one.

Andy.
 
Back
Top