• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!

    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

Awakening the Beastie...trying to!

The good news is that there is/was life. That bit of encouragement should help give you incentive to keep going.

Coils don't often go bad. The problem is likely to be elsewhere. I'd repeat your test with a spark plug (and a single wire) connected directly to the center post of the coil... bypassing the distributor cap, rotor, and plug wires completely. That should help you pin down where you are loosing the spark.

Anyway, give that some thought and congratulations on getting that spark even if it only lasted for a second or two. It's all very encouraging.
 
Don't forget that it takes more than just 12v to the coil to get something out. It actually only produces a spark at the instant where the 12v (or ground on the other side) is interrupted.

My next step would be to double-check your splice. As a soldering newbie, you may have had a "cold" joint or something that opened up from the vibration, or something like that.

Or it could be that there is another problem, and that's why the DPO cut the wires.
 
Back
Top