• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.

    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

Anybody wire in a volt gage?

VelodromeRacer

Jedi Trainee
Offline
Trying to fit an old non stock voltage gauge
into my BJ8. Any ideas on what should wire into it?
 
It's just monitoring system voltage so get a lead to + from any convenient hot post and run a second lead from the other the other contact to any ground. If the posts are not marked check polarity with a set of test leads.
 
I guess it depends on what you are trying to monitor. Voltage @ the battery will tell you the overall condition of storage in very small increments (difficult to see on the gauge)and you would need a relay or switch to disconnect the gauge. The voltage output of the generator or alt. can be important in terms of are you adding to the electrical system; however if the voltage does not make it back to the battery then all is for not. The easy way is to watch the voltage @ the switched side of the key or ignition. Looking @ voltage going to the ignition will allow you to see the effects of the charging system. Just after start (low voltage), increase RPM and watch the charging system overcome low voltage.
 
Back
Top