• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

TR2/3/3A 1960 TR 3A excessive 3" to 4" steering wheel play.

Share this page

Tinkerman

Tinkerman

Darth Vader
Offline
I have about 3 to 4 inches of play in my steering. This is a brand new front end and has never been on the road. Before I start hanging front end sheet metal I would like my steering correct. Any thoughts on a starting point? In the rebuild I used all new or NOS parts. Everything was rebuilt according to the tech manuals. Any thoughts or ideas would be greatly appreciated. Cheers, Tinkerman
 
On mine, it was perished silentblocs.....
 
Can you feel the tight spot with the center link disconnected from the Pitman arm? It should be very slight, but noticeable. If not, I suggest that your box isn't adjusted properly. Getting all the end play out of the box is critical as well, I wound up using a dial indicator to check it as the feeler gauge method didn't seem to come out right. The book doesn't really mention it, but I feel it is important to back off the top adjustment (or just remove the top) while setting the end float. Then afterwards, of course, set it back so you can just feel the tight spot.

Note that it is normal (design feature) to have some small play when the steering is off-center. While driving, the camber in the front suspension will take up the play.

Otherwise it's just a matter of examining every point and finding where the play creeps in. I went through a similar exercise a few months back, and discovered that the new peg had worked loose in the rocker arm. I must not have got it mounted properly or something. I also had a hard time getting the steering wheel locked tightly to the shaft; had to add a flat washer under the nut and I suspect it is working its way loose again.

FWIW, I got mad at the original silentblocs long ago, as they never seemed to last more than a few years (probably due to poor quality replacement parts). Replaced them with brass bushings and SS pins from BFE. The Delrin ones from TRF (and ARE) are probably just as good but I haven't worn out the brass ones yet. (I also added grease zerks so I could lube them from time to time.)
 
Back
Top