• Hi Guest!
    You can help ensure that British Car Forum (BCF) continues to provide a great place to engage in the British car hobby! If you find BCF a beneficial community, please consider supporting our efforts with a subscription.

    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

1098 motor

bansheedave

Member
Offline
I have a 1098 that has some issues. One cylinder has rust in it. I was able to tear the motor down except the one piston. I have an idea to get it out. I also found the motor was over heated at some point in its life by the four corner seize marks on the one piston and the bearings don't look very well.

My question is can a 1098 motor be bored out to a 1200 size? I don't think the one cylinder will clean up even up to 40 over. I'm just curious.
 
1098's are a dime a dozen. I have a 10CC and a 10CG you can have for the hauling. I'd replace with a 1275 or a very cheap 10CC.

Kurt.
 
Well, come to find out after getting the piston out, the cylinder would have cleaned up nicely. I stress would have. I found a 4 inch crack down the cylinder wall. This block is officially a boat anchor.
 
Back
Top