I replaced tie rod ends on 1956 BN2 and I need some info on how to proceed with setting the wheels for proper alignment. Manual states that front of wheels should be 1/8 inch narrower than rear of front wheels (toe in). The replacement tie rod ends from Moss are not the same (length of threaded section) as the ones that were removed. When I removed the old tie rod ends, I counted the number of revolutions/threads and when I installed the new tie rod ends I "eyeballed" the number of revolutions to get me back to where I started from. When turning center rod, I can't seem to get to the 1/8 inch toe in. Any ideas would be appreciated. Thanks, Mike
[ 03-31-2004: Message edited by: elgatto ]</p>
[ 03-31-2004: Message edited by: elgatto ]</p>