• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

100-4 shroud

Share this page

D

dh100m

Member
Offline
hi
I am trying to fit my front shroud having difficulty with brackets from front of chassi that bolt to bottom of shroud cannot fine any suitable pix I need to define the correct height of shroud where it
bolts to these bracket from top of chassi rail if anyone has pix greatly appreciated
thanks in advance tony
icon9.png
 
Tony--

There is a 3" wide Z-shaped bracket that attaches to the frame rail and a smaller L-shaped bracket that attaches the shroud to it. The visible dimensions of the front vertical face of the Z-shaped bracket below the lower edge of the shroud are 1/4" on the inboard edge and 1-3/4" on the outboard edge. It seems to me that these dimensions defines the "height of the shroud" that you ask about. Of course they might vary from car to car depending upon shroud dimensions, etc. Let me know if you need more info.

I have tried several times to attach a photo of the points of attachment and the upload has failed. Perhaps there is a problem with the BCF--perhaps one on my end. In any case if you send me your email either in a pm or reply I will send a pic of the bracket to you off-forum.
 
Back
Top