• Hi Guest!
    You can help ensure that British Car Forum (BCF) continues to provide a great place to engage in the British car hobby! If you find BCF a beneficial community, please consider supporting our efforts with a subscription.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

Wedge TR7 Carburetor losing dashpot oil

Share this page

D

Deleted member 13031

Guest
Guest
Offline
The previous owner installed manual choke carburetors on my US market 1980 TR7. It has a pair of ZS CD175's. The car runs resonably well and starts fine. Idle and acceleration are a bit sputtery, but the biggest problem is that the forward carb loses its dashpot oil over 3 days even if it is not used, and 150 km if it is. The rear carb needs a dashpot top up every 60 days or 500 km. I tried different fluids but that is just avoiding the repair. I had a mechanic replace the needle "o" rings with no change.

The previous owned cannot tell me what the carburettors came off. He says they are original TR7 carbs but i don't think there was a North American TR7 with factory manual choke. In addition to this, one carb had a vented plunger knob and the the other didn't. The mechanic drilled a hole in the non-vented knob(?). They are black in colour.

What is going on? Could it be the wrong needles? Could the diaphragm be leaking? Could it be the wrong "o" rings? There is no good local service for Triumph or Zenith Stromberg carburetors. The little brass ID tag is missing off both carbs. I am reluctant to take the carbs off the car and send them away because the car is in paid storage only until May. If i don't get the carbs back on the car and get it out of the garage it will cost me $125 per month.

Does anyone have a solution, suggestion or a set of carburettors?
Geoff
 
The manual choke kit can be bought after market so the carbs could be correct
 
+1 on Tdskip's post. However, "not having to take the carbs apart" depends on your definition of the task. Since replacing the needle o-rings involves taking the piston out and disturbing the needle location (fuel/air mix) I consider this a task that not everyone is up to. However, it is not beyond the scope for a confident DIYer using the instructions in the article linked above. Just remember if you do this task yourself you will need to tune the carbs after you are done.
 
GeoffreyK said:
In addition to this, one carb had a vented plunger knob and the the other didn't. The mechanic drilled a hole in the non-vented knob(?). They are black in colour.
Click to expand...
Very likely, the vent hole was not required and the vented knob is from some other carb. The space under the knob does need to be vented, but all of the CD175s that I've seen have an internal vent for that space.

However, since you say your mechanic has already replaced the O-rings once and you're still losing oil; I wonder if perhaps you are overfilling. As long as you can feel resistance for the last 1/4" or so of travel when you insert the plunger, there is "enough" oil. If you put in too much, it leaks out through the vent and through the sliding joint.
 
Didn't 75-76 tr7s have manual chokes?? Also, I put new o-rings in last year and one carb still uses twice the oil of the other.
 
Some of the O-rings that seal the damper well might be a bit loose on the adjuster and that may be why they leak.
I've noticed that on several carbs that had their O-rings recently replaced, yet leak. I didn't ask where they came from. I get mine from Joe Curto.
 
Canadian TR7s all had manual chokes unless, of course, they were fuel injected.
 
Back
Top