OK, got my car on the road after initial run in a week ago, ran it up and down the rpm range and sometimes under load for a good break in. Here is my oil pressure, cold- 50 at idle, 75 above 2500rpm. hot- slightly less than 25 at idle and 65 above 2500rpm. Does a little less than 25 seem low for hot idle?. Engine temp is good, I am running the aux. oil line to the valve train.----------Some of you might remember I installed the Supra 5sp conversion from Australia--everything worked and shifted flawless. Also I installed the Ocala CV joint axle conversion, thats the one that Alana installed, they worked flawless. ---Even though the trans conversion is working great I wouldnt recomend that company from Australia because there is a big lack of customer support, hard to get through on the phone (and expensive) and emails go unanswered, because of this-- things are left to your own thought and engineering on some of the installation, the instruction are very generic and not detailed, it would probably be alot better to stay with one of the American conversions.